Our Products

Economy Modular

Recessed Switch Start, Fits both 15 mm and 25 mm T-Bar Ceiling Gridsrs,
Recessed Switch Start,Recessed High Frequency ,Fits both 15 mm and 25 mm T-Bar Ceiling Grids
All fi ttings supplied c/w Cat 2 wishbone type louvre

Surface Switch Start. Surface High Frequency
All fittings supplied c/w Cat 2 wishbone type louvre

IP54 Recessed Modular

The body of the fi tting is fi tted with a polyurethane gasket around its outside lip. To which is attached the cover frame. This is the fi xed to the body by means of screws, which when fully tightened give an IP54 seal. There are two versions, the first has a Cat 2 louvre within the body of the fitting, which is the sealed by a clear PMMA diffuser fi tted to the frame. The second has an opal diffuser fitted to the frame

Non-Corrosive range

High Frequency, Cold Store (-25°C), 3hr Integral Emergency pack, 3hr Integral LED Emergency pack, Self Test, Fused Terminal Block Stainless Steel Clips,Polycarbonate Diffuser, 110 Site Version (110V) (not available on 6’), Tripod Mountable, Through Wired.

Highlight Range

The body is constructed from trimmed sheet steel surface coated with
thermohardened polyuerethane powder (RAL9003). The diffuser is made
from perforated sheet with a semi cylindrical curvature. This allows
diffuse sidewards and downward light distribution.Supplied with 1.25M suspension kit

The body is constructed from an aluminium profi le, the side plates are
fi nished with silver powder coating(RAL7001). There is a Cat 2 louvre
fi tted in the base of the fi tting and the top of the fi tting is fi tted with a
clear cover to allow upward as well as downward distribution of light.
Supplied with 1.25M suspension kit-Size.2 x 28W T5 S 1188 W 330 H 109

The body is constructed from an extruded aluminium profile. The
perforated shades at the sides are surface coated with thermohardened
polyuerethane powder (RAL9003). The top of the fi tting is sealed with a
prismatic diffuser, allowing the upward transmission of light. The lower
tube is placed in an opal acrylic tubular diffuser.
Supplied with 1.25M suspension kit

The body is constructed from perforated sheet steel surface coated
with thermohardened polyuerethane powder (RAL9003). The top of
the fi tting is sealed with a prismatic diffuser, allowing the upward
transmission of light Supplied with 1.25M suspension kit

Next

Previous